Jacuzzi J-230 Manual Do Utilizador

A grounding wire connector is provided on this unit to connect a 

• 

minimum No. 8 AWG (8.4 mm²) solid copper conductor between this 

unit and any metal equipment, metal enclosures of electrical equipment, 

metal water pipe, or conduit within 5 feet (1.5m) of the unit. 

Never permit any electrical appliance, such as a light, telephone, radio, 

• 

television, etc. within 5 feet (1.5m) of a spa unless such appliances are 

built-in by the manufacturer.

Never bring any electrical appliances into or near the spa. 

• 

Never operate any electrical appliances from inside the spa or when you 

• 

are wet.

The electrical supply for this product must include a suitably rated switch 

• 

or circuit breaker to open all ungrounded supply conductors to comply 

with section 422-20 of the National Electrical Code/USA, ANSI/NFPA 70. 

The disconnecting means must be readily accessible and visible to the 

spa occupant but installed at least 5 feet (1.5m), from the spa.

The electrical circuit supplied for the hot tub must include a suitable 

• 

ground fault circuit interrupter (GFCI) as required by NEC Article 680-42.

4.

!

Extreme caution must be exercised to prevent diving or jumping into 

• 

the spa or slipping and falling, which could result in unconsciousness, 

drowning, or serious injury. Remember that wet surfaces can be very 

slippery.

Never stand, walk or sit on the top railing of the spa.

• 

5.

!

Water temperature in excess of 104°F (40°F) may be injurious to your 

• 

health. 

Refer to section 3.2 Hyperthermia for specific causes and symptoms of 

• 

this condition.

The water in the spa should never exceed 104°F (40°C). Water 

• 

temperatures between 100°F (38°C) and 104°F (40°C) are considered 

safe for a healthy adult. 

Lower water temperatures are recommended for young children 

• 

(children are especially sensitive to hot water) and when spa use may 

exceed 10 minutes.

The Consumer Products Safety Commission/USA has stated that the 

• 

water temperature in a spa should not exceed 104°F (40°C). 

Always test the spa water temperature before entering the spa. 

• 

The user should measure the water temperature with an accurate 

thermometer since the tolerance of water temperature-regulating 

devices may vary as much as +/- 5°F (2°C).