ATTO Technology FC-21PS Manual Do Utilizador

  

• If these do not solve the problem, re-flash the 

storage adapter and re-install the Windows 
2000/XP/Server 2003 driver. See 

Configuring 

and updating drivers

 on page 21.

Right-click My Computer.

Select Properties.

Select the Hardware tab 

Select Device Manager.

If the Celerity FC storage adapter does not 
appear under the SCSI and RAID controllers, 
shut down and make sure the Celerity FC 
storage adapter is properly seated in the PCI 
slot.

 a. Remove power from the PC.
 b. Remove its case.
 c. Check the PCI slot.
 d. Replace the case.
 e. Apply power. 

Reload the driver (see 

Configuring and 

updating drivers

 on page 21).

If the adapter has been identified but there is an 
exclamation point (!) on the listing, right click on 
the listing and select Uninstall. 

Reboot the system and repeat the installation 
process. 

If problems persist, contact your authorized 
ATTO Technology representative.

Verify the celerityfc driver is loaded with the 

lsmod 

command. If lsmod does not show the 

driver, refer to the installation instructions to 
install and load the driver in 

Configuring and 

updating drivers

 on page 21.

Check the system log with the command 

. The celerityfc driver creates status 

messages during initialization. Make sure that 
all installed cards are properly detected and 
initialized.

Examine the contents of the file(s) 
/proc/scsi/celerityfc/X, where X is the 

adapter’s host number. This file contains details 
such as link status, connection speed and 
discovered devices.

Note