Amana AGR5844VD Instrução De Instalação

Página de 20
17
4. Turn gas pressure regulator cap counterclockwise with a 
⁵⁄₈" combination wrench to remove.
NOTE: Do not remove the spring beneath the cap.
5. Turn over the gas pressure regulator cap and reinstall on 
regulator so that the solid end faces out and the marking 
“<- NG” is facing the direction shown in the above drawing.
6. Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners
1. Remove burner cap. 
2. Using a Phillips or Quadrex
®
 screwdriver, remove the burner 
base.
NOTE: Reinstall one of the screws through the range cooktop 
to hold the orifice spud holder in place while removing and 
replacing the orifice spuds.
3. Apply masking tape to the end of a 
⁵⁄₁₆" nut driver to help hold 
the gas orifice spud in the nut driver while changing it. Press 
nut driver down onto the gas orifice spud and remove by 
turning it counterclockwise and lifting out. Set gas orifice 
spud aside. 
4. Gas orifice spuds are stamped with a number on the side. 
Replace the LP gas orifice spud with the correct Natural gas 
orifice spud.
Refer to the following chart for the correct Natural gas orifice 
spud placement. 
Natural Gas Orifice Spud Chart
NOTE: Refer to the Model Number and Serial Number Plate 
located behind the left side of the storage or warming drawer for 
proper sizing of spuds for each burner location.
5. Place LP gas orifice spuds in plastic parts bag for future use 
and keep with package containing literature. 
6. Replace the burner base using both screws.
7. Replace burner cap.
8. Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner
1. Remove oven racks.
2. Use a ½" combination wrench to loosen the orifice hood 
away from the pin (about 2 to 2½ turns). The oven bake 
burner flame cannot be properly adjusted if this conversion is 
not made. See “Adjust Oven Bake Burner Flame” in the 
“Electronic Ignition System” section.
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
F. Gas regulator shutoff valve (shown in the “open” position)
A. Orifice spud
B. Orifice spud holder
C. Screw
D. Spark electrode
A
B
C
D
Side view before
Side view after
E
NG
LP
LP
NG
F
F
B
A
C
D
A. Stamped number
Burner Rating
Color
Size
ID 
Number
17,000 BTU
15,500 BTU
14,200 BTU
13,000/13,500 BTU
12,000/12,500 BTU
 9,500 BTU
 8,000 BTU
 5,000 BTU
Red/Magenta
Red/Black
Red/Orange
Red/Blue
Red/Yellow
Red/Brown
Red/White
Red/Brass
2.10 mm
2.00 mm
1.90 mm
1.85 mm
1.80 mm
1.55 mm
1.40 mm
1.10 mm
N210
N200
N190
N185
N180
N155
N140
N110
A. Orifice hood
B. Pin
XXX
A
A
B
A
A