ZyXEL P-660HW-D1 Guia Do Utilizador

Prestige 660H/HW Series User’s Guide

Chapter 26 Remote Node Configuration

254

For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node 
Network Layer Options as shown next.

1 In menu 11.1, make sure IP is among the protocols in the Route field. 

2 Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then 

press [ENTER] to display Menu 11.3 – Remote Node Network Layer Options.

Figure 140   Menu 11.3 Remote Node Network Layer Options

Menu 11.3 - Remote Node Network Layer Options

 IP Options:                          Bridge Options:
   IP Address Assignment = Static       Ethernet Addr Timeout(min)= N/A
   Rem IP Addr = 0.0.0.0
   Rem Subnet Mask= 0.0.0.0
   My WAN Addr= 0.0.0.0
   NAT= SUA Only
     Address Mapping Set= N/A
   Metric= 2
   Private= No
   RIP Direction= None
     Version= RIP-1
   Multicast= None
   IP Policies=

Enter here to CONFIRM or ESC to CANCEL:

The next table explains fields in Menu 11.3 – Remote Node Network Layer Options.

Table 85   Menu 11.3 Remote Node Network Layer Options 

IP Address 

Assignment

Press [SPACE BAR] and then [ENTER] to select Dynamic if the remote node is using 

a dynamically assigned IP address or Static if it is using a static (fixed) IP address. 

You will only be able to configure this in the ISP node (also the one you configure in 

menu 4), all other nodes are set to Static.

Rem IP Addr

This is the IP address you entered in the previous menu.

Rem Subnet 

Mask

Type the subnet mask assigned to the remote node.

My WAN Addr

Some implementations, especially UNIX derivatives, require separate IP network 

numbers for the WAN and LAN links and each end to have a unique address within 

the WAN network number. In that case, type the IP address assigned to the WAN port 

of your Prestige.
NOTE: Refers to local Prestige address, not the remote router address.

NAT 

Press [SPACE BAR] and then [ENTER] to select Full Feature if you have multiple 

public WAN IP addresses for your Prestige. 

Select SUA Only if you have just one public WAN IP address for your Prestige. The 

SMT uses Address Mapping Set 255 (see

Select None to disable NAT.