Kenwood KRF-V8030D Manual Do Utilizador
16
Operations
1
Listening to a source component
2
3
3
Start playback from the selected source.
1
"PHONO"
2
"TUNER"
3
"CD/DVD"
4
"TAPE" or "MD"
5
"VIDEO1"
6
"VIDEO2"
7
"VIDEO3"
8
"DVD/6ch"
9
"AV AUX"
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key
to select the source you want to listen to.
to select the source you want to listen to.
Use the VOLUME CONTROL (VOLUME +/–) to adjust the
volume.
volume.
MUSIC
MOVIE
VOLUME+/–
INPUT SELECTOR
VOLUME CONTROL
Selecting a source using the MUSIC key
1
"CD/DVD"
2
"TAPE" or "MD"
3
"TUNER"
4
"PHONO"
1
"VIDEO1"
2
"VIDEO2"
3
"VIDEO3"
4
"DVD/6ch"
5
"AV AUX"
Selecting a source using the MOVIE key
Preparing for playback
Normal playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1
Turn on the power to the related components.
2
Turn on the power to this receiver by pressing POWER or
SYS.POWER
SYS.POWER
(and ON/STANDBY) key(s).
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “
the MD/TAPE jacks. The initial factory setting is “
TAPE
”. To change the
source name associated with the MD/TAPE jacks to “
MD
,” follow the
steps below:
1
Use the INPUT SELECTOR knob to select “MD/TAPE”.
2
Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “
MD
”.
• To return to the original indication, repeat the above procedure.
A ON
:
Sound from the speakers connected to the
SPEAKERS A
terminals on the rear panel.
B ON
:
Sound from the speakers connected to the
SPEAKERS B
terminals on the rear panel.
A+B ON :
Sound from both the speakers connected to the
SPEAK-
ERS A
and
B
terminals on the rear panel.
A+B OFF :
No sound from the speakers. Use this setting when listening
with headphones for stereo sound and virtual surround in all
playback modes.
with headphones for stereo sound and virtual surround in all
playback modes.
Selecting the input mode
If you have selected a component connected to the
CD, DVD, VIDEO2,
or
VIDEO3
jacks, make sure that the input mode setting is correct for the
type of audio signal to be used.
9
AUTO
INPUT MODE
POWER
ON/STANDBY
INPUT SELECTOR
SPEAKERS A/B
LFE
C
S
RS
LS
TI.VOL
CLIP
MUTE
RDS
EON
PTY
TP
TA
NEWS
L
SP
A
R
SW
B
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
be used.
The indicator for the speakers you
want to use should be lit.
want to use should be lit.
• Activating a surround mode or selecting “DVD 6ch” as the input
source causes speaker system A to be selected automatically.
• When you use the
PRE OUT
jacks, press the only
SPEAKERS A
key
to the on position.