Sony KDL-40S2000 Guia Do Utilizador
9
(GB)
SU-WL51
2-652-380-11(1)
If you intend to install a TV or monitor that is not specified
on page 2, be sure to refer to the leaflet “Installing the Wall-
Mount Bracket” supplied with your TV or monitor.
on page 2, be sure to refer to the leaflet “Installing the Wall-
Mount Bracket” supplied with your TV or monitor.
Step 5:
Installing the TV or
monitor on the Plate Unit
Installing the TV or
monitor on the Plate Unit
WARNING
Be sure to complete the installation before connecting the
AC power cord to the wall outlet. If you allow the AC
power cord to be pinched under or between pieces of
equipment, this may result in a short circuit or an electric
shock.
Be careful not to stumble over the AC power cord or the
TV or monitor, as you may hurt yourself.
AC power cord to the wall outlet. If you allow the AC
power cord to be pinched under or between pieces of
equipment, this may result in a short circuit or an electric
shock.
Be careful not to stumble over the AC power cord or the
TV or monitor, as you may hurt yourself.
1
Attach the Mounting Hook Units
on the hooks on the rear side of
the TV or monitor. Then slide the
Mounting Hook Units, as
illustrated below, and secure
them using the supplied screws
(+PSW5 × L16).
on the hooks on the rear side of
the TV or monitor. Then slide the
Mounting Hook Units, as
illustrated below, and secure
them using the supplied screws
(+PSW5 × L16).
Note
Be sure not to use any screws other than the supplied ones
(+PSW5 × L16) when securing the Mounting Hook Units.
(+PSW5 × L16) when securing the Mounting Hook Units.
Rear side of the TV or monitor
Soft cloth
2
Connect the AC power cord and
the connecting cable(s) supplied
with the TV or monitor to the TV
or monitor.
the connecting cable(s) supplied
with the TV or monitor to the TV
or monitor.
Connect the AC power cord and the connecting
cable(s) to the connectors on the rear side of the TV or
monitor. For details on connecting the AC power cord
and the connecting cable(s), refer to the instruction
manual of the TV or monitor.
cable(s) to the connectors on the rear side of the TV or
monitor. For details on connecting the AC power cord
and the connecting cable(s), refer to the instruction
manual of the TV or monitor.
When you route the cord and the cable in the wall, feed
them through the bored hole (page 13).
them through the bored hole (page 13).
Notes
• You cannot connect the cables to the TV or monitor after
installing it on the Plate Unit.
• Subcontract the cable routing in the wall to licensed
contractors.
(Continued)
01GB01COV.book Page 9 Tuesday, December 20, 2005 4:59 PM