NEC NP300 Guia Do Utilizador
76
6. Maintenance
SEL
ECT
ME
NU
EXI
T
ENTER
STA
TUS
LAM
P
AUTOA
DJ.
SOU
RCE
FO
CU
S
This section describes the simple maintenance procedures you should follow to clean the filters and replace the lamp.
1 Cleaning or Replacing the Filters
The air-filter sponge keeps dust and dirt from getting inside the projector and should be frequently cleaned. If the filter
is dirty or clogged, your projector may overheat.
is dirty or clogged, your projector may overheat.
NOTE: The message for filter cleaning will be displayed for one minute after the projector is turned on or off.
To cancel the message, press any button on the projector cabinet or the remote control.
To cancel the message, press any button on the projector cabinet or the remote control.
CAUTION
• Turn off the projector, turn off the main power switch and unplug the projector before replacing the filters.
• Only clean the outside of the filter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the filter cover.
• Only clean the outside of the filter cover with a vacuum cleaner.
• Do not attempt to operate the projector without the filter cover.
To clean the ar-filter:
Vacuum the filter-through the filter cover.
To replace the filter (sponge):
1. Remove the filter cover (2 locations) by pushing up on the catch of the cover until you feel it detach.
SEL
ECT
ME
NU
EX
IT
ENTER
STA
TUS
LAMP
AUT
OAD
J.
SOU
RCE
FO
CUS
2. Replace two filters.
(1) Gently peel off the filter (sponge) and clean the filter cover.
(2) Attach the new filter to the filter cover.
(1) Gently peel off the filter (sponge) and clean the filter cover.
(2) Attach the new filter to the filter cover.