Hoshizaki FH1-SSB(-HD) Guia Do Utilizador

6

Cap

Bolt

Handle

(d) Attach the adjustable legs or the casters provided to the bottom of the cabinet. (Not 

required for Roll In or Roll Thru units).

4. For Roll In and Roll Thru units only, remove the internal packaging. Be careful not to 

damage the unit when removing the internal packaging.

1) If the unit is supplied with an overflow pan or electrically heated condensate pan, install 

as outlined in "I.C.. Overflow Pan" or "I.C.3. Electrically Heated Condensate Pan." 
After the pan is installed or if the unit does not use a pan, continue to step .   

) Visually check that the refrigerant lines do not rub or touch other lines or surfaces and 

that the fan blades turn freely.

3) Check that the compressor is snug on all mounting pads.
4) Position the unit in the selected location. 

• For units with legs, level in both the front-to-back and side-to-side directions. Turn the 

bottom portion of the legs to lower or raise them. 

• For units with casters, no adjustment is necessary.
• For Roll In or Roll Thru units, seal the perimeter of the unit with NSF-approved, 

food-grade silicone and then see "I.C.4. Food Cart Ramp."

5) Install the shelves (if applicable) using the shelf support clips provided in the accessory 

pack. Indexing holes are provided on the pilasters in evenly spaced intervals to assist 
you in positioning the support clips at the same height. Two and three section units 
may be equipped with center shelves which should be installed after the main shelves 
are in place. The center shelf kit contains additional clip(s) which support the center 
shelf when the main shelves on one side of the cabinet are not aligned with the main 
shelves of the other side of the cabinet.* See Fig. 1.

*Without this additional support, under adverse loading conditions, the shelf 
assembly could tip.

6) On units without pre-installed door handle(s), install the door handle(s) as illustrated. 

See Fig. . 

Main Shelf

Center Shelf

Main Shelf

Clip