Bosch ltc-0335-28 Guia Do Utilizador
14
en | Displaying camera images
Bosch Video Management System
Operator Client | V3 | 2010.07
Operator's Manual
Bosch Sicherheitssysteme GmbH
A sequence can be configured to use more than one Image pane. If there are not enough Image
panes to display the whole sequence, only those Image panes are displayed which fit into the
Image window. The remaining Image panes are not displayed and an appropriate message is
displayed.
Under the following conditions, a sequence is not being displayed:
–
Video loss
–
Connection to the camera lost
–
No permission to display the camera
–
Camera not configured
In addition, for sequences displayed on an analog monitor via a decoder, DiBos cameras
cannot be displayed.
To start and control a camera sequence:
1.
Drag the required sequence
from the Logical Tree window to an Image pane.
The sequence is displayed indicated by the
symbol.
2.
Click a playback control icon of the Image window toolbar to control the sequence.
5.7
Starting an automatic camera sequence
Main window
With a camera sequence, a group of cameras are displayed one after the other.
You configure the dwell time for these sequences in the Options dialog box (Extras menu,
Options... command).
Under the following conditions, a sequence is not being displayed:
–
Video loss
–
Connection to the camera lost
–
No permission to display the camera
–
Camera not configured
In addition, for sequences displayed on an analog monitor via a decoder, DiBos cameras
cannot be displayed.
NOTICE!
When the configuration is changed and activated, a camera sequence (pre-configured or
automatic) usually is continued after restart of the Operator Client.
But in the following cases the sequence is not continued:
–
A monitor where the sequence is configured to be displayed has been removed.
–
The mode of a monitor (single/quad view) where the sequence is configured to be
displayed has been changed.
–
The logical number of a monitor where the sequence is configured to be displayed is
changed.
NOTICE!
When the configuration is changed and activated, a camera sequence (pre-configured or
automatic) usually is continued after restart of the Operator Client.
But in the following cases the sequence is not continued:
–
A monitor where the sequence is configured to be displayed has been removed.
–
The mode of a monitor (single/quad view) where the sequence is configured to be
displayed has been changed.
–
The logical number of a monitor where the sequence is configured to be displayed is
changed.