Sanyo PLC-WTC500AL Manual Do Utilizador

Press the P-TIMER button on the remote control. The P-Timer 

display “00:00” appears on the screen and the countdown 

starts (00:00–59:59).

To stop the countdown, press the P-TIMER button. To cancel 

the P-Timer function, press the P-TIMER button again.

P-Timer display

✔

Reduce the upper width 
with the Point 

e

 button. 

Reduce the lower width 
with the Point 

d

 button.  

Press the KEYSTONE button on the remote control. The 

“Keystone” appears on the screen.

Use the Point ed7 8 buttons to correct keystone 

distortion. The keystone adjustment can be stored

 (p.45).

• The white arrows indicate that there is no correction.

• A red arrow indicates the direction of correction.

• An arrow disappears at the maximum correction.

• If you press the KEYSTONE button on the remote 

control again while the Keystone dialog box is being 

displayed, the keystone adjustment will be canceled.

• The adjustable range can be limited depending on the 

input signal.

• “Keystone” disappears after 10 seconds.

See pages 28 and 58 for details.

Reduce  the  left  part  with 

Point 

7

 

button.  

Reduce  the  right  part  with 

Point 

8

 button.  

Press the PIP button on the remote control to select Picture

in Picture or Picture by Picture mode. See page 52 for 

details.

Press the PIP VOL. button on the remote control at the PIP 

mode. The volume dialog box appears. Use the Point 7 8 

buttons to adjust the volume.