Sanyo PLC-WTC500L Manual Do Utilizador

This projector uses a high-pressure lamp which must be handled carefully and properly.  

Improper handling may result in accidents, injury, or create a fire hazard.

l

 Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee 

of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time 

than other similar lamps.

l

 If the projector indicates that the lamp should be replaced, i.e., if the LAMP 1/2 REPLACE indicators 

lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.  

    (Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of 

the lamp with the LAMP 1/2 REPLACE indicators lighted may increase the risk of lamp explosion.  

l

 A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its 

lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in 

which the projector and lamp are being used.

If  a  lamp  explodes,  disconnect  the  projector’s  AC  plug  from  the  AC  outlet  immediately.  Contact  an 

authorized  service  station  for  a  checkup  of  the  unit  and  replacement  of  the  lamp.  Additionally,  check 

carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out 

from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one 

should  check  the  inside  of  the  projector  except  those  who  are  authorized  trained  technicians  and  who 

are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those 

who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken 

glass.

Replacement lamp can be ordered through your dealer. When ordering, give the following information to the dealer.

l

l

  Replacement Lamp Type No . 

  

(Service Parts No. 610 342 2626)