Sanyo PLC-WXU300 Guia Do Utilizador

The preparation display will disappear

after 30 seconds.

(See page 55 for Lamp control status.)

Connect the projector’s AC power cord into an AC

outlet. The POWER indicator lights red. Open the lens

cap (see pages 8, 63).
Press the ON/STAND-BY button on the top control or

on the remote control. The POWER indicator lights

green and the cooling fans start to operate. The

preparation display appears on the screen and the

countdown starts.

After the countdown, the input source that was

selected the last time and the lamp control status icon

(see page 55) appear on the screen.

Complete peripheral connections (with a computer,

VCR, etc.) before turning on the projector.

Note:
 • When the Logo select function is set to Off, the logo will

not be shown on the screen (p.47).

 • When Countdown off or Off is selected in the Display

function, the countdown will not be shown on the screen

(p.46).

 • During the countdown period, all operations are invalid.

 • When the Input Search function is set to On, the input

signal will be searched automatically (p.45)

 • When Off is selected in the Display function, the Video/

PC  selection  window  and  the  input  signal  guidance

window are not shown on the screen. (p.46)

Note:
  The Filter warning and Lamp replacement

icons may appear on the screen depending

on the usage state of the projector.

Lamp control status

If there is no signal input when start on the projector,

or the current signal is missed while operating the

projector, the Video/PC selection window will be

displayed on the screen, please move the pointer to

input source desired by pressing the Point ▲▼ buttons

and press the SELECT button. And then follow the

input signal guidance window to correct the signal and

connection.

If the projector is locked with a PIN code, PIN code

input dialog box will appear. Enter the PIN code as

instructed on the next page.

No signal

Current Input setting Video

VIDEO

S-VIDEO

Is signal processed correctly?
Is cable connected properly?

No signal

Current Input setting COMPUTER1 RGB

Is signal processed correctly?

Is cable connected properly?