Sanyo PLC-XP200L Guia Do Utilizador

Some parts are not used for installation or replacement. 

Keep these parts for later use.

Focus Lock Screw

Focus Lock Ring

Set up the projector and project image on the screen.
1 .  Loosen the Focus Lock Screw on the lens.
2 .  Rotate  the  lens  to  obtain  proper  focus  on  center 

area of the screen. 

3 .  Lock the Focus Lock Screw securely.
When proper focus is not observed at outer area of the 

screen, proceed the following adjustments.
4 .  Loosen the Focus Lock Ring on the lens. (Turn the 

Lock Ring counter-clockwise.)

5 .  Rotate the lens to obtain proper focus on outer area 

of the screen.

6 .  Lock the Focus Lock Ring securely.  (Turn the Lock 

Ring clockwise.)

If proper focus is not observed over the entire screen, 

repeat above adjustments 1~ 6.

After  installing  or  replacing  the  lens,  be 

sure to check the following for safety.

1.  Check the lens is securely fixed 

with the screws.

2.  Check no wiring is damaged or 

tangled on the gear of the lens 

motor or  the other mechanical 

parts.

3.  Check  no  part  is  missing,  and 

no mounting part is loose.

When the lens is attached to the projector and images 

are  being  projected  onto  the  screen,  the  peripheral 

focus  may  be  out  of  focus  in  some  localized  areas.  If 

this happens, insert the one, of three sizes of spacers, 

in between the Lens Attachment and the lens to adjust 

the focus.
Inserting the Spacer corrects the distance on the Lens 

Adjustment and improves the diagonal focus.
The corrected distance is determined by the thickness 

of  the  used  spacers.  As  a  guide,  the  distance  is 

adjusted  by  approximately  30  mm  for  each  0.1-mm 

thickness of the spacers.
There  are  three  types  of  spacers  provided,  and  there 

are  four  of  each  spacer  type.  Use  these  spacers  to 

correct the distance as required.

Spacer "1"
Color; Clear
Thickness; 0.1 mm
Spacer "2"
Color; Black
Thickness; 0.2 mm
Spacer "3"
Color; Cream
Thickness; 0.3 mm

Correction distance
30  mm/for  40-inch 

projection
Correction distance
55  mm/for  40-inch 

projection    
Correction distance
80  mm/for  40-inch 

projection     

Spacer

Lens

Lens Attachment

Screw driver in the lens

✔

Distance

Screen
40-inch projection