Sanyo PLV-Z700 Guia Do Utilizador

Turn the projector on and press the MENU button to display 
the On-Screen Menu. Select the Setting Menu with the Point 

ed

 buttons. Press the Point 

8

 or OK buttons to access the 

submenu items.

Put the blower’s nozzle into a hole.

Blow air into the projector with the blower watching the 

position of the dust from the screen. 

Set the projector back into the right position, then press any 

button on the top control or on the remote control to quit the 

Cleaning function.

Select Cleaning and then press the Point 

8

 or OK buttons. 

The screen is blacked out temporarily.

Turn the projector over. Put your finger on the hole cover’s 

tab and pull to open the hole cover.

When cleaning is done, pull the blower out of the hole and 

replace the hole cover.

Put your finger on 
the hole cover’s tab 
and pull.

The nozzle will go no 
further than a certain 
point when it is put 
into the hole. Do not 
attempt to push the 
nozzle further in, or 
it could break and be 
stuck inside of the 
projector.

* Do not open the hole cover except when you clean the inside of the projector to 

prevent foreign matters from getting into the projector. If it is open especially while 

operating the projector, the optical parts could damage.

 
  Which hole to put the nozzle in?
 
  When you look at the screen:
 

● 

When red spots (dust) are particularly noticeable, put the 
nozzle into the R panel cleaning holes.

 

● 

When green spots (dust) are particularly noticeable, put 
the nozzle into the G panel cleaning holes.

 

● 

When blue spots (dust) are particularly noticeable, put the 
nozzle into the B panel cleaning holes.

Wave the nozzle back and forth inside of the 
projector.
(Do not attempt to bend the nozzle.)

Use only the supplied blower and nozzle.
Do not use a commercially available 
compressed air duster. It causes the 
interior of the projector to malfunction 
with release of cold liquid propellant. We 
could not guarantee the malfunction of 
breakage by using other tools.

Select Cleaning in the 
Setting Menu.

Tab

Hole cover