Audiovox awd510 Manual Do Utilizador

The following troubleshooting guide takes you through some of the more common 

problems associated with the installation and/or operation of a wireless system. If 

the problem persists, please call toll-free 1-800-732-6866 or visit  

www.araccessories.com.

No sound

•  Make sure the transmitter’s AC power adapter is fully inserted into the wall 

outlet and the power cord from the AC adapter is firmly connected to the 

transmitter power input jack.

•  Check that the audio source component (DVD player, TV, etc.) is turned on and 

transmitting sound as it normally should. If you’re using a PC or DVD player, 

make sure you’ve selected the correct audio output and that the sound is not 

muted.

•  Confirm that the headphones are turned on (the LED is blue) and tuned to the 

transmitter. If the LED is not blue, press the ch select key on the transmitter to 

try a different channel. If this doesn’t work, press and hold the mute/link key on 

the headphone and the ch select/link key on the transmitter simultaneously for 3 

seconds.

•  Make sure the headphones are charged—the LED on the right headphone should 

be blue.

•  Check that the headphone volume is turned up.
•  If you’re using a variable output audio source (like a headphone jack or variable 

output on a TV set), make sure the source component’s volume is set high 

enough for the transmitter to detect. 

•  If you are using a Tape 2 Monitor output from your receiver/amp as the audio 

output, check that you have pressed the Tape Monitor/Tape 2 button on the 

front of the receiver. This will turn on the Tape 2 outputs, which may not have 

been active.

Interrupted 

sound

•  Move closer to the transmitter with the headphones on. Sending the signal 

through certain materials, such as glass, tile, and metal, can decrease the effective 

transmitting distance of the system.

•  Try a different channel from the transmitter: press the ch select key on the 

transmitter’s top panel.

LED fails to 

light up

•  Make sure the headphones are charged and that the transmitter is properly 

connected to the audio source. Then, move the headphones close to the 

transmitter and press the headphone power button again. 

Headphones 

shut off 

automatically

•  Move closer to the transmitter. 
•  The headphones’ rechargeable battery needs to be recharged. Use the charging 

cable on the transmitter to recharge the headphones. 

Headphones 

start beeping

•  If you’re trying to find a different channel on the transmitter, the headphones 

beep when they lock onto a new channel.

•  The headphones beep every few seconds when the batteries are running low. Use 

the charging cable on the transmitter to recharge the headphones.