GE DBVH520EJ Guia Do Utilizador

Stacking.

4. Prepare the Washer

and Dryer

A. Place the washer in the approximate

location.

B. Make sure the washer is level.

Refer to washer Installation
Instructions for details.

C. Remove the back portion of

the control panel by removing
the 3 screws.

D. Reverse dryer door swing if desired.

See dryer Installation Instructions
for details.

NOTE: The washer door swing is not
reversible.

INSTALLING THE STACK BRACKET KIT (cont.)

5. Install Dryer and Bracket

on Washer

A. Lift the dryer on top of the washer.

Be careful not to scratch the top
of the washer with the brackets.
Protect the washer control panel
with cardboard or other protection.
Be sure to lift the dryer high enough
to clear the washer control panel.

WARNING!

Potential Personal Injury. More than
two people are recommended to lift
the dryer into position because of its
weight and size. Failure to do so could
result in personal injury or death.

B. Align the holes in the bracket

with the holes in the back of
the washer. Using a Phillips
screwdriver, attach the 2 #8 x 1/2

″

tapping screws. Repeat on both
sides of the washer.

6. Finalize the Installation

A. Refer to the washer Installation

Instructions to complete the washer
installation.

B. Refer to the dryer Installation

Instructions to complete the dryer
installation.

C. Carefully slide or walk the stacked

washer and dryer into place. Use
felt pads or other sliding device
to assist moving and to protect
flooring.

WARNING!

Potential Personal Injury. Do not push
on the dryer once installed to top of
the washer. Pushing on the dryer may
result in pinched fingers.

Place
hands
here

Operating

Instructions

Safety

Instructions

Consumer

uppor

oubleshooting

Tips