TallyGenicom 2365 Guia Do Utilizador
The Menu
User guide
86
If this option is disabled (Off), then the printer advances paper 1/8
inch when exiting oversized characters. This characteristic is re-
tained for compatibility with older products.
inch when exiting oversized characters. This characteristic is re-
tained for compatibility with older products.
If the option is enabled (On), then the current vertical position follow-
ing the printing of an oversized character will be the top of the over-
sized character cell. If the next object on the page is located below
this point, then the printer uses vertical logic seeking to economize
on paper movement.
ing the printing of an oversized character will be the top of the over-
sized character cell. If the next object on the page is located below
this point, then the printer uses vertical logic seeking to economize
on paper movement.
Confirm the setting by pressing the Set key (1).
Vertical position after
oversized character
(LCPtop)
oversized character
(LCPtop)
This paramater controls the vertical position of characters with stan-
dard height which follow oversized characters.
dard height which follow oversized characters.
This function is only effective in Genicom ANSI emulation.
Press LCPtop (3) key.
Use the < (2) or > (3) key to select the desired setting.
Setting Options: Off/On
Default Setting: Off
Default Setting: Off
If this option is disabled (Off), then the printer advances paper 1/8
inch when exiting oversized characters. This characteristic is re-
tained for compatibility with older products.
inch when exiting oversized characters. This characteristic is re-
tained for compatibility with older products.
If the option is enabled (On), then the current vertical position follow-
ing the printing of an oversized character will be the top of the over-
sized character cell. If the next object on the page is located below
this point, then the printer uses vertical logic seeking to economize
on paper movement.
ing the printing of an oversized character will be the top of the over-
sized character cell. If the next object on the page is located below
this point, then the printer uses vertical logic seeking to economize
on paper movement.
Confirm the setting by pressing the Set key (1). Press the Next key
(4) to access the next group of parameters.
(4) to access the next group of parameters.