Lexmark W850DN Guia Do Utilizador

To prevent print quality problems, avoid getting fingerprints on the transparencies.

Before loading transparencies, fan the stack to prevent sheets from sticking together.

We recommend Lexmark transparencies. For ordering information, see the Lexmark Web site at

www.lexmark.com.

Print samples on the envelopes being considered for use before buying large quantities.

Use envelopes designed specifically for laser printers. Check with the manufacturer or vendor to ensure that the

envelopes can withstand temperatures up to 220°C (446°F) without sealing, wrinkling, curling excessively, or

releasing hazardous emissions.

For best performance, use envelopes made from 90 g/m

2

 (24 lb bond) paper or 25% cotton. All-cotton envelopes

must not exceed 70 g/m

2

 (20 lb bond) weight.

Use only new envelopes from undamaged packages.

To optimize performance and minimize jams, do not use envelopes that:

Have excessive curl or twist

Are stuck together or damaged in any way

Have windows, holes, perforations, cutouts, or embossing

Have metal clasps, string ties, or folding bars

Have an interlocking design

Have postage stamps attached

Have any exposed adhesive when the flap is in the sealed or closed position

Have bent corners

Have rough, cockle, or laid finishes

Adjust the width guides to fit the width of the envelopes.

Note: A combination of high humidity (over 60%) and the high printing temperature may wrinkle or seal envelopes.

Note: This printer is intended for occasional paper label printing only.
For detailed information on label printing, characteristics, and design, see the Card Stock & Label Guide available on
the Lexmark Web site at www.lexmark.com/publications.

Do not load labels together with paper or transparencies in the same source; mixing media can cause feeding

problems.

From the Paper menu, set the Paper Type to Labels.

Do not use labels with slick backing material.

Use labels that can withstand temperatures of 230°C (446°F) without sealing, excessive curling, wrinkling, or

releasing hazardous emissions.

Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a jam. Partial sheets

also contaminate the printer and the cartridge with adhesive, and could void the printer and cartridge warranties.

Do not use labels with exposed adhesive.

Do not print within 1 mm (0.04 in.) of the edge of the label, of the perforations, or between die-cuts of the label.

Be sure adhesive backing does not reach to the sheet edge. Zone coating of the adhesive at least 1 mm (0.04 in.)

away from edges is recommended. Adhesive material contaminates the printer and could void the warranty.

Printing