Alcatel-Lucent 6850-48 Guia De Rede
Configuring RIP
Quick Steps for Configuring RIP Routing
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 28-3
Quick Steps for Configuring RIP Routing
To forward packets to a device on a different VLAN, you must create a router interface on each VLAN.
To route packets by using RIP, you must enable RIP and create a RIP interface on the router interface. The
following steps show you how to enable RIP routing between VLANs “from scratch”. If active VLANs
and router ports have already been created on the switch, go to Step 7.
To route packets by using RIP, you must enable RIP and create a RIP interface on the router interface. The
following steps show you how to enable RIP routing between VLANs “from scratch”. If active VLANs
and router ports have already been created on the switch, go to Step 7.
1 Create VLAN 1 with a description (e.g., VLAN 1) by using the
command. For example:
-> vlan 1 name “VLAN 1”
2 Create VLAN 2 with a description (e.g., VLAN 2) by using the vlan command. For example:
-> vlan 2 name “VLAN 2”
3 Assign an active port to VLAN 1 by using the
ing command assigns port 1 on slot 1 to VLAN 1:
-> vlan 1 port default 1/1
4 Assign an active port to VLAN 2 by using the vlan port default command. For example, the follow-
ing command assigns port 2 on slot 1 to VLAN 2:
ing command assigns port 2 on slot 1 to VLAN 2:
-> vlan 2 port default 1/2
5 Configure an IP interface to enable IP routing on a VLAN by using the
command. For
example:
-> ip interface vlan-1 address 171.10.1.1 vlan 1
6 Configure an IP interface to enable IP routing on a VLAN by using the ip interface command. For
example:
example:
-> ip interface vlan-2 address 171.11.1.1 vlan 2
7 Load RIP into the switch memory by using the
command. For example:
-> ip load rip
8 Enable RIP on the switch by using the
command. For example:
-> ip rip status enable
-> ip rip interface vlan-1
10 Enable the RIP interface by using the
command. For example:
-> ip rip interface vlan-1 status enable
11 Create an RIP interface on VLAN 2 by using the ip rip interface command. For example:
-> ip rip interface vlan-2
Note
.
For more information on VLANs and router ports, see