Alcatel-Lucent 6850-48 Guia De Rede
Configuring RIP
RIP Options
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 28-11
Enabling a RIP Host Route
A host route differs from a network route, which is a route to a specific network. This command allows a
direct connection to the host without using the RIP table. If a switch is directly attached to a host on a
network, use the
direct connection to the host without using the RIP table. If a switch is directly attached to a host on a
network, use the
command to enable a default route to the host. For example:
-> ip rip host-route
The default is to enable a default host route.
Use the no ip rip host-route command to disable the host route. Use the show ip rip command to display
the current host route status.
the current host route status.