Alcatel-Lucent 6850-48 Guia De Referência
VLAN Management Commands
OmniSwitch CLI Reference Guide
September 2009
page 21-17
show vlan
Displays a list of VLANs and their attributes configured on the switch.
show vlan [vid1 [-vid2]]
Syntax Definitions
vid1
The VLAN ID number (2–4094).
-vid2
The last VLAN ID number in a range of VLANs that you want to
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
configure (e.g. 10-12 specifies VLANs 10, 11, and 12).
Defaults
By default, a list of all VLANs and their attributes are displayed.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Specify a VLAN ID with this command to display information about a specific VLAN.
• Note that specifying a range of VLAN IDs is also allowed. Use a hyphen to indicate a contiguous
range (e.g., show vlan 10-15). Note that only one VLAN entry—a single VLAN ID or a range of
VLAN IDs— is allowed with this command. Multiple entries are not accepted.
VLAN IDs— is allowed with this command. Multiple entries are not accepted.
Examples
-> show vlan
stree mble src
vlan type admin oper 1x1 flat auth ip ipx tag lrn name
-----+-----+------+-----+----+-----+----+-----+-----+-----+-----+---------
1 std on on on on off off NA off on VLAN 1
100 vstk on off off on off off NA off off VLAN 100
-> show vlan 1
Name : VLAN 1,
Administrative State: enabled,
Operational State : enabled,
1x1 Spanning Tree State : enabled,
Flat Spanning Tree State : enabled,
Authentication : disabled,
IP Router Port : off,
IPX Router Port : none,
Mobile Tag : off,
Source Learning : enabled