Humminbird 777c2 Guia De Utilização
45
46
Alarms Menu Tab
From any view, press the MENU key twice to access
the Main Menu System. The Alarms tab will be the
default selection.
the Main Menu System. The Alarms tab will be the
default selection.
NOTE: When an alarm is triggered, you can silence it by
pressing any key. The alarm will be silenced, and will not
be triggered again until a new instance of the alarm
condition is detected.
pressing any key. The alarm will be silenced, and will not
be triggered again until a new instance of the alarm
condition is detected.
Alarms Menu
Water Type
(Advanced)
Water Type configures your unit for operation in fresh or salt water. The Water Type
menu choice is available when User Mode is set to Advanced (see Setup Menu Tab:
User Mode).
menu choice is available when User Mode is set to Advanced (see Setup Menu Tab:
User Mode).
NOTE: In salt water, what would be considered a large fish might be 2 to 10 times bigger
than a large fish in fresh water (depending on the type of fish you are seeking). The salt
water setting allows for a greater range in fish size adjustment to account for this. Also,
make sure that the Water Type is set accurately, especially in salt water, as this affects the
accuracy of deep water depth readings.
than a large fish in fresh water (depending on the type of fish you are seeking). The salt
water setting allows for a greater range in fish size adjustment to account for this. Also,
make sure that the Water Type is set accurately, especially in salt water, as this affects the
accuracy of deep water depth readings.
To change the Water Type setting:
1. Make sure you are in Advanced User Mode, then highlight Water Type on the
Sonar main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the Water Type
setting. (Fresh, Salt, Default = Fresh)
Transducer Select
Transducer Select allows you to select which
transducer you want to use (the 700 Series™ Fishing System comes with a DualBeam
PLUS™ transducer, and also supports the optional-purchase QuadraBeam™ and
WideSide® transducers.)
PLUS™ transducer, and also supports the optional-purchase QuadraBeam™ and
WideSide® transducers.)
To change the selected Transducer:
1. Highlight Transducer Select on the Sonar Main menu.
2. Use the LEFT or RIGHT 4-WAY Cursor Control keys to change the transducer
selected. (DualBeam, QuadBeam, WideSide, Default = DualBeam)
531474-1_A_777c2_English.qxd 11/3/2005 8:02 PM Page 52