Intellinet 519021 Guia Do Utilizador
Modularized 24+2G Switch
7
2-2. Module Type Configuration
The switch is modularized. In addition to two GBIC ports, there are three
modules selectable for your needs. For the different type modules, some
module/port settings maybe need to be reconfigured. You can configure
the module type by this function. The system can also configure all the
port settings of the module to the pre-defined values for you. If some of
the detail settings of each port do not meet your needs, you can change
them on a port-by-port basis from the Port Controls Page. The default
module type is 8-port 10/100 Base-TX RJ-45.
Available module types:
1. No
Module
2.
8-Port 10/100 Base-TX RJ-45
3. 4-Port 100 Base-FX ST/SC
4. 8-Port 100 Base-FX LC
5. 8-Port 100 Base-FX MT-RJ
4. 8-Port 100 Base-FX LC
5. 8-Port 100 Base-FX MT-RJ
6.
8-Port 100 Base-FX BiDi
• Warning: The modules are not hot swappable. You must
turn off the power before you change the modules. Failure
to do so may result in damage to the Switch.
to do so may result in damage to the Switch.
Modularized 24+2G Switch
8
2-3. Port status
This page can see every port status that depended on user setting and
the negotiation result.
the negotiation result.
1. State:
Display port statuses disable or enable. “unlink” will be
treated as “off ”.
2. Link Status:
Down is “No Link”, UP is “Link”.
3. Auto-Negotiation:
Display the auto-negotiation mode:
auto/force/NWay.
4. Speed status:
Display 1000Mbps or 100Mbps or 10Mbps speed,
port 1- 24 are 10/100Mbps, Port 25-26 are 10/100/1000Mbps
(depending on the modular card used).
(depending on the modular card used).
5. Duplex status:
Display full duplex or half-duplex mode.
6. Flow Control:
Full: Display the flow control status is enable or disable in full mode.