Printronix SL4M Guia Do Utilizador
190
Chapter
6
Restore The Printer To Operation
B12 ERROR:
PROGRAM MISSING
Repeat Download
PROGRAM MISSING
Repeat Download
Yes
The printer cannot find
the data controller
program or the
validation checksum is
corrupt.
the data controller
program or the
validation checksum is
corrupt.
Power off the printer for 15
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
seconds, then power back
on. If the problem persists,
contact your authorized
customer service
representative.
B13 ERROR:
NOT COMPATIBLE
NOT COMPATIBLE
Yes
An attempt was made
to download firmware
for a different printer
type.
to download firmware
for a different printer
type.
Cycle power. Repeat
download for correct printer
type.
download for correct printer
type.
B22 ERROR:
DECOMPRESS SIZE
Repeat Download
DECOMPRESS SIZE
Repeat Download
Yes
Problem when
downloading.
downloading.
Cycle power. If problem
persists repeat download.
persists repeat download.
B23 ERROR:
DECOMPRESS CKSUM
Repeat Download
DECOMPRESS CKSUM
Repeat Download
Yes
Problem when
downloading.
downloading.
Cycle power. If problem
persists repeat download.
persists repeat download.
BAD VFU CHANNEL
Yes
The user tried to use an
undefined VFU
channel.
undefined VFU
channel.
Use defined channels.
CALIBRATION FAIL
See User Manual
See User Manual
Yes
Calibration values
derived from Manual
Calibrate were not
acceptable.
derived from Manual
Calibrate were not
acceptable.
Perform a Run Manual Cal
(run manual calibrate) again.
(run manual calibrate) again.
CANNOT CALIBRATE
Disable Peel-Off
Disable Peel-Off
Yes
Run Auto-Calibrate was
attempted with Peel-Off
Media Handling
selected.
NOTE: You can
perform Auto Calibrate
in Peel-Off mode if Cal
in Peel Mode = Enable.
Be prepared to catch
labels during Run
Auto-Calibrate.
attempted with Peel-Off
Media Handling
selected.
NOTE: You can
perform Auto Calibrate
in Peel-Off mode if Cal
in Peel Mode = Enable.
Be prepared to catch
labels during Run
Auto-Calibrate.
1.
Select another Media
Handling option in the
MEDIA SETUP menu.
Handling option in the
MEDIA SETUP menu.
2.
Enable Cal in Peel Mode
in the SENSOR SETUP
menu.
NOTE: Admin User must
= Enable in the
PRINTER SETUP menu.
in the SENSOR SETUP
menu.
NOTE: Admin User must
= Enable in the
PRINTER SETUP menu.
CARTRIDGE REMOVED
Check Cartridge
Check Cartridge
Yes
The cartridge was
removed while the
printer was powered
on.
removed while the
printer was powered
on.
1.
Power off the printer.
2.
Install the cartridge.
3.
Power on the printer.
Copy Complete
Run Auto-Cal
After Reboot
Run Auto-Cal
After Reboot
Yes
The QCMC has
finished copying to the
printer.
finished copying to the
printer.
Wait for the printer to reboot,
then Run Auto-Cal under the
Sensor Setup menu.
then Run Auto-Cal under the
Sensor Setup menu.
Table 14. Fault Messages
Displayed Message
Can User
Correct?
Explanation
Solution