Printronix SL4M Manual Do Utilizador
Printer Alarms
183
Printer Alarms
The printer has built-in alarms that monitor printer status and media stock
conditions. Alarm messages display indicating the present status of the
printer and media stock levels. The alarms also indicate if the printer
electronics detect an error condition.
conditions. Alarm messages display indicating the present status of the
printer and media stock levels. The alarms also indicate if the printer
electronics detect an error condition.
RIBBON
Printer cuts (melts) through
the transfer ribbon.
the transfer ribbon.
1.
Verify that Print Intensity is set to the proper level in the
MEDIA SETUP menu.
MEDIA SETUP menu.
2.
Verify that Print Mode in the MEDIA SETUP menu is set
for Transfer and not Direct Thermal.
for Transfer and not Direct Thermal.
Printing stops and the FAULT
status indicator flashes.
status indicator flashes.
1.
Check that the media sensor is clean and undamaged.
2.
Check that the gap between the bottom of a label and the
top of the next label is at least 0.100 inch. Use only labels
and tag stock approved for this printer.
top of the next label is at least 0.100 inch. Use only labels
and tag stock approved for this printer.
3.
Inspect for a jammed label. Remove the jammed label.
4.
Check that the transfer ribbon and label stock are routed
correctly.
correctly.
Table 13. Printer Problems and Solutions (continued)
Symptom
Solution/Explanation