Printronix P5000LJ Manual De Referência
162
Chapter
5
Configuring the Epson FX-1050 Emulation with Control Codes
Double High Print, Set/Reset
ASCII Code ESC w
n
Hex Code
1B 77
n
Dec Code
27 119
n
Purpose
Turns double-high character printing on and off. Double-high
characters are standard width but twice as high.
characters are standard width but twice as high.
where
n = 1 or 49 (hex 01 or hex 31) turns double high printing on
n = 0 or 48 (hex 00 or hex 30) turns double high printing off
n = 0 or 48 (hex 00 or hex 30) turns double high printing off
Discussion The OCR A and OCR B fonts cannot be printed in double high.
If Superscript/Subscript (ESC S) or Condensed Print (SI) is
combined with Double High printing,
combined with Double High printing,
only Double High printing
will occur.
Example
The following sample illustrates double-high character printing.
Double Strike
ASCII Code ESC G
Hex Code
1B 47
Dec Code
27 71
Purpose
Makes text bolder by double printing each dot twice.
Discussion This command makes text bolder by printing each dot twice, the
second dot offset to the right of the first by a distance equal to
1/2 the width of a dot, the same as with ESC E.
1/2 the width of a dot, the same as with ESC E.
Example
The following sample illustrates double strike character printing.
Note
It is recommended to use double Line Feeds and Carriage Returns when
double-high character printing is on (after an ESC w control code has been
sent), or else the printer will overstrike text that has already printed.
double-high character printing is on (after an ESC w control code has been
sent), or else the printer will overstrike text that has already printed.