Toshiba M30 Guia Do Utilizador
Getting Started
Satellite M30 Series
3-9
Satellite M30 Series
Version
1
Last Saved on 10.09.2003 13:12
ENGLISH using Mies10 Online.dot –– Printed on 10.09.2003 as
Automatic Hibernation
The computer will enter Hibernate mode automatically when you press
the power button or close the lid. First, however, make the appropriate
settings according to the steps below.
the power button or close the lid. First, however, make the appropriate
settings according to the steps below.
1. Open
the
Control Panel.
2. Open Performance and Maintenance and open Power Options.
3. Select
the
Hibernate window in the
Power Options Properties
,
select the Enable hibernation check box and click the Apply button.
4. Open TOSHIBA Power Saver.
5. Select
the
Setup Action window.
6. Enable the desired Hibernation settings for When I press the power
button and When I close the lid.
7. Click the OK button.
Data save in hibernation mode
When you turn off the power in hibernation mode, the computer takes a
moment to save current memory data to the hard disk. During this time,
the Disk indicator will light.
moment to save current memory data to the hard disk. During this time,
the Disk indicator will light.
After you turn off the computer and memory is saved to the hard disk,
turn off the power to any peripheral devices.
turn off the power to any peripheral devices.
Do not turn the computer or devices back on immediately. Wait a moment
to let all capacitors fully discharge.
to let all capacitors fully discharge.
Standby mode
If you have to interrupt your work, you can turn off the power without
exiting from your software. Data is maintained in the computer’s main
memory. When you turn on the power again, you can continue working
right where you left off.
exiting from your software. Data is maintained in the computer’s main
memory. When you turn on the power again, you can continue working
right where you left off.
When the AC adaptor is connected, the computer will go into Standby
mode according to the settings in the TOSHIBA Power Saver utility.
mode according to the settings in the TOSHIBA Power Saver utility.
To restore operation from Standby mode, press the power button or press
any key. The latter action works only if Wake-up on Keyboard is enabled in
HW Setup.
any key. The latter action works only if Wake-up on Keyboard is enabled in
HW Setup.
If the computer automatically enters Standby mode while a network
application is active, the application might not be restored when the
computer wakes up from Standby.
application is active, the application might not be restored when the
computer wakes up from Standby.
To prevent the computer from automatically entering Standby mode,
disable Standby in TOSHIBA Power Saver. That action, however, will
nullify the computer’s Energy Star compliance.
disable Standby in TOSHIBA Power Saver. That action, however, will
nullify the computer’s Energy Star compliance.