Toshiba M30 Guia Do Utilizador
Operating Basics
Satellite M30 Series
4-26
Satellite M30 Series
Version
1
Last Saved on 10.09.2003 13:55
ENGLISH using Mies10 Online.dot –– Printed on 10.09.2003 as
Set the switch to off in airplanes and hospitals. Check the indicator. It will
stop glowing when the wireless communication function is off.
stop glowing when the wireless communication function is off.
Turn the computer off when you enter an airplane and check the carrier’s
regulations before you use a computer on board.
regulations before you use a computer on board.
Wireless communication indicator
The wireless communication indicator indicates the status of the wireless
communication functions.
communication functions.
Indicator
status Indication
Indicator off
Wireless communication switch is set to off.
Indicator glows Wireless communication switch is on.
Wireless LAN is turned on by an application.
If you used the Task Bar to disable W-LAN, restart the computer or follow
the procedures below to enable the system to recognize W-LAN. Open or
click the following: start, Control Panel, System, Hardware Device
Manager, Network adapters, Intel
the procedures below to enable the system to recognize W-LAN. Open or
click the following: start, Control Panel, System, Hardware Device
Manager, Network adapters, Intel
®
PRO/Wireless LAN 2100 3B Mini
PCI Adapter or Intel
®
PRO/Wireless LAN 2100A 3B Mini PCI Adapter
or Atheros AR5001X+ Wireless Network Adapter and enable.
LAN
The computer has built-in support for Ethernet LAN (10 megabits per
second, 10BASE-T) and Fast Ethernet LAN (100 megabits per second,
100BASE-Tx).
This section describes how to connect/disconnect to a LAN.
second, 10BASE-T) and Fast Ethernet LAN (100 megabits per second,
100BASE-Tx).
This section describes how to connect/disconnect to a LAN.
Do not install or remove an optional memory module while Wake-up on
LAN is enabled.
LAN is enabled.
Do not connect any cable other than a LAN cable to the LAN jack. It
could cause damage or malfunction.
could cause damage or malfunction.
Do not connect the LAN cable to a power supply. It could cause damage
or malfunction.
or malfunction.
The Wake-up on LAN function consumes power even when the system is
off. Leave the universal AC adaptor connected while using this feature.
off. Leave the universal AC adaptor connected while using this feature.
When the Wake-up on LAN function is activated, the LAN indicators do
not glow while the computer is in standby mode (while it is waiting for a
LAN wake-up signal).
not glow while the computer is in standby mode (while it is waiting for a
LAN wake-up signal).