Netgear GS116 Instrução De Instalação

)NSTALLATION

Estimated Time: 5–10 minutes

When you open the box, verify that you received everything. The package includes:

•

NETGEAR 16-port Gigabit Switch Model GS116

•

AC power adapter

•

Wall-mounting screws

•

GS116 Installation Guide (this document)

•

Warranty/support information card

If you do not have everything listed above, see the support information card for contact 
information. If you are missing the support information card, get contact information at 
http://www.NETGEAR.com in the Technical Support section.

Decide where you want to place the switch. Find a flat horizontal surface such as a table, 
desk or shelf. The switch comes with wall-mounting screws. You can use the screws if you 
want to hang the switch in an open space on a wall.

Make sure the selected location is:

•

Not in direct sunlight or near a heater or heating vent.

•

Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on 
all sides of the switch.

•

Well ventilated (especially if it is in a closet).

Also, you will need one Category 5 (Cat 5) Ethernet cable with RJ-45 connectors for each 
device you want to connect to the switch. Each Ethernet cable must be less than 328 feet 
(100 meters).

1.

Place the switch on a flat surface or hook onto the screws.

2.

For each device, insert one end of an Ethernet cable into the port in the device and 
insert the other end into one of the Ethernet ports on the switch.

3.

Connect the power adapter cord into the back of the switch and then plug the adapter 
into a power source (such as a wall socket or power strip).

The Power light should light up.

4.

Check the LEDs to confirm that all connections are correct. 

Power

• On: 16-port Gigabit Switch has power.
• Off: No power.

RJ-45 ports

• Right LED on: 10 Mbps connection to a powered device.
• Left LED on: 100 Mbps connection to a powered device.
• Both LEDs on: 1000 Mbps connection to a powered device.
• Blink: Activity on this port. 

!UTO

5PLINK

,/#!,
-

!UTO

5PLINK

Power

Thank you for selecting NETGEAR products. 

After completing the Smart Wizard configuration assistant, locate the serial number on the 
bottom label of your product, and use it to register your product at 
http://www.NETGEAR.com/register. 
Registration on the website or over the phone is required before you can use our telephone 
support service. The phone numbers for worldwide regional customer support centers are 
on the Warranty and Support Information card that came with your product. 

Go to 

http://kbserver.netgear.com for product updates and Web support. 

Power light is not lit

The switch has no power. Make sure that:
• The power cord is properly connected to the switch.
• The power adapter is properly connected to a functioning power 

outlet. If it is in a power strip, make sure the power strip is turned 
on. If the socket is controlled by a light switch, make sure the 
switch is in the on position.

• You are using the NETGEAR power adapter supplied with your 

switch.

Port number light is 
not lit for a connected 
device, or stays on 
continuously

There is a hardware connection problem.
• Make sure the cable connectors are securely plugged in at the 

switch and the device.

• Make sure the connected device is turned on.
• If the Ethernet cable is connected to a NIC or other Ethernet 

adapter, make sure the card or adapter is installed correctly and 
is working.

• Make sure the cable is less than 328 feet (100 meters).