Netgear GS504 Guia Da Instalação

 

Model GS504 4-Port Gigabit Switch Installation Guide

 

Power LED is off.

No power is received 
at the hub.

Check the power cord connections for the 
switch and the connected device.
Make sure all cables used are correct and 
comply with Ethernet specifications. 

Link LED is off or 
intermittent.

Port connection is 
not functioning.

Check the crimp on the fiber connectors and 
make sure that the plug is properly inserted 
and locked into the port at both the switch 
and the connecting device.
Make sure all cables used are correct and 
comply with Ethernet specifications.
Check for a defective adapter card, cable, or 
port by testing them in an alternate 
environment where all products are 
functioning.

File transfer is 
slow or 
performance 
degradation is a 
problem.

Half- or full-duplex 
setting on the 
NETGEAR switch 
and the connected 
device are not the 
same.

Make sure the remote link partner is set to 
autonegotiate or forced to full-duplex 
operation. 

A segment or 
device is not 
recognized as 
part of the 
network.

One or more devices 
are not properly 
connected, or 
cabling does not 
meet Ethernet 
guidelines.

Verify that the cabling is correct. Be sure all 
cable connectors are securely positioned in 
the required ports. Equipment may have 
been accidentally disconnected.

FDX/Col LED is 
blinking yellow 
excessively.

Collisions are 
occurring on the 
connected segment.

Some collisions are normal when the 
connection is operating in half-duplex mode.

Duplex modes are 
mismatched.

Recheck the link partner settings.