Adtran 1335 Folheto

Quick Start Guide, 61700515E2-13A, November 2006

Copyright © 2006 ADTRAN, All Rights Reserved

For more detailed documentation, visit us online at 

www.adtran.com

.

Two configuration methods are available for your NetVanta 1335 Series units:

•

Web-based GUI

•

AOS Command Line Interface (CLI)

The GUI lets you configure the main unit settings and provides online guidance and explanations for 
each setting. However, using the AOS CLI may be necessary for more advanced configurations. 

You may access the web-based GUI from any web browser on your network by following these 
steps:

1.

Connect the switch to your PC using any of the 24 Ethernet ports on the front of the unit.

2.

Set your PC to a fixed IP address of 10.10.10.2. If you cannot change the PC’s IP address, you 
will need to change the unit’s IP address using the CLI. (Refer to the next two sections for 
instructions.)

3.

Enter the unit’s IP address in your browser address line. The default IP address is 10.10.10.1.

4.

You will then be prompted for the username and password (the default settings are admin and 
password).

5.

The initial GUI screen appears.

Access the AOS CLI via the CONSOLE port or a Telnet session. To establish a connection to the 
NetVanta unit’s CONSOLE port, you need the following items:

•

VT100 terminal or PC (with VT100 terminal emulation software)

•

Straight-through serial cable with a DB-9 (male) connector on one end and the appropriate 
interface for your terminal or PC communication port on the other end

1.

Connect the DB-9 (male) connector of your serial cable to the CONSOLE port on the rear panel 
of the unit.

2.

Connect the other end of the serial cable to the terminal or PC.

3.

Insert the connector of the provided power cord into the power interface on the rear panel of 
the unit, and plug the cord into a standard electrical outlet.

4.

Once the unit is powered up, open a VT100 terminal session using the following settings: 
9600 baud, 8 data bits, no parity bits, and 1 stop bit. Press <Enter> to activate the AOS CLI.

5.

Enter enable at the > prompt. Enter the enable password when prompted. The default 
password is password.

The following steps create an IP address and subnet mask for the virtual interface vlan 1. If you 
are not sure what IP address to assign, please contact your network administrator.

1.

At the # prompt, enter config terminal.

2.

At the (config)# prompt, enter interface vlan 1 to access the configuration parameters for 
the virtual LAN (VLAN) interface.

3.

Enter ip address 10.26.12.12 255.255.255.0 to assign an IP address to the VLAN interface 
using a 24-bit subnet mask.

4.

Enter no shutdown to activate the virtual interface to pass data.

5.

Enter exit to return to the Global Configuration mode.