Adtran 600R Manual Do Utilizador

61200624L1-1B

© 2004 ADTRAN, Inc.

 235

 allows the service provider to gain initial access to a newly installed IAD while in its factory 

default state. This eliminates the need for a skilled technician on-site during installation, as it only requires 
someone to make the network interface and power connections to the IAD. After accessing the unit, the 
service provider remotely loads a configuration script. A fail-safe timer is then set and the configuration is 
saved. Next, the service provider reprovisions the network to match the IAD's configuration and accesses 
the unit. If the service provider can access the unit, the 

 was successful, the unit is 

operational, and the fail-safe timer should be cancelled. If access is not gained prior to the fail-safe timer 
expiration, the fail-safe mechanism is invoked and the IAD returns to the default configuration. 

This DLP details the steps involved in an IAD installation using the 

 feature.

The unit must be at factory default. If the unit is not a new unit, factory default the unit by one of the 
following methods:
•

Select 

. At the > prompt, type fac. You will then see “Restore Factory 

Defaults and Reset Unit? (press Y).” Press the Y key to confirm default. The unit then resets.

•

If connected to the 

 port (must be at 9600 baud), power reset the unit and then restore power to 

the unit while holding down the F key. You will then be prompted to confirm the factory default.

Obtain the desired configuration file. The config file may be one of the following two formats:
•

A .cfg file which is loaded via TFTP. See DLP-9, Saving the Current Configuration Using TFTP.

•

A script obtained via the terminal mode. See DLP-13 (Saving the Router's Configuration section only).

•

VT100 compatible terminal or computer with terminal emulation software (only required if unit has to 
be factory defaulted)

•

Appropriate cable to connect terminal to the unit (customer-provided, only required if unit has to be 
factory defaulted)

•

DB-9 female to RJ-48 female adapter (ADTRAN proprietary) for connecting to the 

 port on the 

rear of the unit (see CRAFT Port on page 31).