Adtran 600R Manual Do Utilizador
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
87
I
NTERFACES
(FXO) > C
ONFIG
Configure the FXO mode, line impedance, and Tandem parameters from this menu.
I
NTERFACES
(FXO) > C
ONFIG
> P
ORT
Indicates the port of the FXO module.
I
NTERFACES
(FXO) > C
ONFIG
> M
ODE
Choices are given below. Default is
L
OOP
S
TART
.
I
NTERFACES
(FXO) > C
ONFIG
> T
X
(
d
B)
Sets the TX direction level points. This signal will change the volume of the voice. TX (dB) is the signal
that is transmitted out the T1, with 0 dB being the strongest. If the volume is too loud across the T1, this
number should be increased. A higher number indicates more attenuation which equals lower volume. The
value entered must be less than 10 dB. Default is
that is transmitted out the T1, with 0 dB being the strongest. If the volume is too loud across the T1, this
number should be increased. A higher number indicates more attenuation which equals lower volume. The
value entered must be less than 10 dB. Default is
0.0 dB
.
I
NTERFACES
(FXO) > C
ONFIG
> R
X
(
d
B)
Sets the RX direction level points. This signal will change the volume of the voice for the signal being
transmitted by the Total Access 6XX out the interface. A higher number indicates more attenuation which
equals lower volume. The value entered must be less than 10 dB. Default is
transmitted by the Total Access 6XX out the interface. A higher number indicates more attenuation which
equals lower volume. The value entered must be less than 10 dB. Default is
0.0 dB
.
I
NTERFACES
(FXO) > C
ONFIG
> S
VC
M
ODE
Indicates whether the module is
I
N
S
ERVICE
or
O
UT
OF
S
VC
. This does not indicate whether the port has
been mapped.
I
NTERFACES
(FXO) > S
TATUS
Displays the status of the FXO signal bits.
This mode must match the network configuration and/or how each port is being used. Each
port on the FXO Module is independent and should be set accordingly.
port on the FXO Module is independent and should be set accordingly.
L
OOP
S
TART
Sets the port to use FXO loop start signaling on the T-span and loop
start supervision on the analog 2-wire interface.
start supervision on the analog 2-wire interface.
G
ROUND
S
TART
Sets the port to use FXO ground start signaling on the T-span and
ground start supervision on the analog 2-wire interface.
ground start supervision on the analog 2-wire interface.
DPT
Sets the port to use Dial Pulse signaling to terminate dialed numbers.
M
ODIFIED
DPT
Sets the port to use DPT signaling on the interface. In DPT mode, digits
are transmitted out the FXO interface to the user equipment. DPT mode
is one-way operation for outbound calls towards user equipment on the
2-wire side.
are transmitted out the FXO interface to the user equipment. DPT mode
is one-way operation for outbound calls towards user equipment on the
2-wire side.