Adtran 340 Folheto

Quick Start Guide, 61200422E1-13B, July 2006

Technical Support 1-888-4ADTRAN (1-888-423-8726)

Copyright © 2006 ADTRAN, All Rights Reserved

For more detailed documentation, visit us online at 

www.adtran.com

.

Two configuration methods are available for your NetVanta router:

•

Web-based GUI

•

AOS Command Line Interface (CLI)

The GUI lets you configure the main unit settings and provides online guidance and explanations for 
each setting. However, using the AOS CLI may be necessary for more advanced configurations. 

You may access the web-based GUI from any web browser on your network by following these 
steps:

1.

Connect the router to your PC using one of the ETHERNET ports on the back of the unit.

2.

During bootup your PC will obtain an IP address from the NetVanta 300 Series unit’s DHCP 
server. By default, both the DHCP and HTTP servers are enabled. 

3.

Enter the unit’s IP address in your browser address line. The default IP address is 10.10.10.1.

4.

You will then be prompted for the username and password (the default settings are admin and 
password).

5.

The initial GUI screen appears.

6.

Click on Getting Started in the System menu on the left side of your screen and follow the on-
line instructions.

1.

Click on the Getting Started link under the System menu. This brings up a side bar page. 

2.

Click on Step 1 - Configure the Public Interface at the top of the side bar page to open the 
ATM PVC page.

3.

Enter the PVC number and select an Interface Mode. Usually this is PPP or PPPoE; 
however, if IP routing is chosen, you will need to enter an IP address.

4.

Click Apply. If PPP or PPPoE is selected as the Interface Mode, you will be taken to the 
PPP page after clicking Apply.  Here you will need to select the type of authentication 
needed, authentication passwords, and the Address Type. In most cases you will want the 
Address Type to be Negotiated.  Click Apply when all the information is complete.

If needed, you can access the AOS CLI via a Telnet session. 

1.

Telnet to the unit’s IP address. The default IP address is 10.10.10.1.

2.

You will then be prompted for the username and password (the default settings are admin 
and password).

3.

Enter enable at the > prompt.

4.

Enter the enable password when prompted. The default password is password.

•

If the factory default switch (shown in the back panel illustrations on the next page) is 
pressed during bootup, the unit will stay in bootstrap mode. Since the unit has no serial port, 
Telnet has been built into the boot code. The default IP address is 10.10.10.1.

•

If the factory default switch is pressed and held for 5 seconds after boot, the ETHERNET 
interface on the NetVanta 340 (or the VLAN 1 interface on the NetVanta 344 and 
NetVanta 347) will default to 10.10.10.1 and all access policies will be removed from that 
interface. 

•

If the factory default switch is pressed and held for 30 seconds, a default configuration will 
overwrite your existing configuration and reboot the unit.