Adtran 544r Manual Técnico
Section 5 DLP-5
Total Access 544R System Manual
112
© 2003 ADTRAN, Inc.
61200704L2-1B
1. Ascertain the unit IP address.
If you do not already have the IP Address for the unit, obtain it from the Network Administrator or
manually check for the address in the R
manually check for the address in the R
OUTER
/C
ONFIG
/I
NTERFACES
(E
TH
)/S
ETUP
/P
RIMARY
IP/IP A
DDRESS
menu.
2. Ping the unit from a remote computer on the network.
Using a remote computer system connected to the LAN, perform an ICMP Ping on the IP Address of
the unit. Verify that the unit responds properly.
the unit. Verify that the unit responds properly.
If the unit fails to respond, try the following:
•
•
Verify that the proper IP Address, Subnet Mask, and Default Gateway are provisioned in the unit
(see DLP-4, Setting Ethernet IP Parametersfor details).
(see DLP-4, Setting Ethernet IP Parametersfor details).
•
Verify that the unit is properly cabled into the LAN and that the Ethernet cable is properly seated
in the RJ-45
in the RJ-45
10/100B
ASE
T
port on the rear of the unit.
•
Verify the LAN link light on the front of the unit is lit. If not lit, check the cabling between the hub
and the unit.
and the unit.
•
If the unit is connected to a hub or other network device that provides a carrier sense light for each
port, verify that the carrier sense light for the port to which the unit is connected is lit. If this light
is not lit, check the cabling between the hub and the unit.
port, verify that the carrier sense light for the port to which the unit is connected is lit. If this light
is not lit, check the cabling between the hub and the unit.
•
Verify the IP Address, Subnet Mask, and Default Gateway on the remote computer system.
•
Use Ethernet straight-through cable for connection to hub or switch. Use Ethernet crossover if
connecting to a PC.
connecting to a PC.
If none of these steps are successful, contact the LAN Administrator for assistance.
Perform Steps Below in the Order Listed
You must log in with a security level of
C
ONFIG
,
S
UPPORT
, or
F
ULL
to modify the IP
parameters on the unit.
Refer to the documentation of the computer system if you are unsure how to perform a Ping
command. Most computers running a networked version of Microsoft Windows™ or UNIX
allow a Ping to be performed by simply typing ping <IP Address> at a command line
prompt. Typically, the Ping program will respond by indicating that the remote IP Address
has responded in a certain amount of time or that no response was received.
command. Most computers running a networked version of Microsoft Windows™ or UNIX
allow a Ping to be performed by simply typing ping <IP Address> at a command line
prompt. Typically, the Ping program will respond by indicating that the remote IP Address
has responded in a certain amount of time or that no response was received.
Some versions of Ping will continue running until you explicitly tell them to stop. If the
program does not terminate on its own, type
program does not terminate on its own, type
<Ctrl+C>
to get the program to stop.