Adtran 544r Manual Técnico

Section 5  DLP-1 

Total Access 544R System Manual

 98

© 2003 ADTRAN, Inc.

61200704L2-1B

1. Connect a VT100 terminal to the unit.

2. Connect a PC emulating a VT100 terminal to the unit.

3. Most personal computers or laptops can run communications software that will emulate a VT100 

terminal. Windows programs such as Terminal

©

 or Hyperterminal

©

 are two such examples in the 

Windows format. However, there are many other adequate, commercially available software packages 
which will allow your PC or laptop to emulate a VT100 terminal. Certain configuration items must be 
set on a PC or laptop for it to act as a VT100 terminal for the unit.

4. Press <Enter> or <Ctrl + R> until the Login menu appears on screen.

You are now ready to log in to the unit, as described in DLP-2, Logging in to the System. 

•

Set the parameters of the VT100 terminal to:
–

9600 baud rate

–

8 data bits

–

No parity

–

1 stop bit

–

No flow control

•

If the terminal has a parallel setting, disable it and use serial port. 

•

Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by 
using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make the connection to the VT100 
terminal as appropriate for your equipment.

•

Set the PC for direct connect on the appropriate com port (instead of dial-up connection).

•

Set the parameters of the communications software to:
–

9600 baud rate

–

8 data bits

–

No parity

–

1 stop bit

–

No flow control

•

Plug the RJ-45 male end of the data cable into the CRAFT port on the rear of the unit by 
using the ADTRAN-proprietary DB-9 to RJ-45 adapter. Make connection to the PC or laptop 
as appropriate for your equipment.