Mitsubishi wd-52628 Manual Do Utilizador

Through NetCommand, you can automatically start and 

stop recordings and send signals from one playback 
device to a recording device.  Recordings can be made 
on recordable devices connected to the TV.

The TV can convert digital channels and IEEE 1394 

device signals to analog signals that can be recorded on 
NetCommand-compatible analog VHS and S-VHS VCRs.

You can schedule the recording to take place at a later 

time and program the recording duration for a minimum 
of 30 minutes and a maximum of six hours (in 30-minute 
increments).  The default is one hour.  During the 
recording, you can view a different device or power off 
the TV.

Can be used when viewing Antenna 1 or 2, an IEEE 1394 
device, or a non-recording traditional device.

To initiate recording now:

1.  Press REC (record) on the TV remote.

2.  In the “Record to” section, review the destination 

device and duration.  Use ADJUST   or   to change, 
if necessary.

3.  Press a second time and the recording will start.

1.  Set the TV to the source you want to record.

2  Press REC (record) on the TV remote.

3.  Press ADJUST   or   to select the Record To device, 

duration time, start time (press ENTER after selecting 

hour, minutes and AM or PM to set the time) and day, 
using ADJUST   or   to change.  For devices that 

can select channels, select the channel.

4.  Select Add and press ENTER to add the recording 

to the record list.  If your selection is successful, a 
confirmation message will be displayed.  If you pick 
overlapping times, day(s), or destination devices, you 
will see a message stating there is a conflict.

5.  To exit, press HOME on the TV remote after all 

recordings have been added.

Press GUIDE while viewing the Record To screen to see a 
list of all currently programmed recordings.  A maximum 
of 32 recordings can be scheduled.

To cancel a recording on the Record List, press ADJUST   

or   to select the recording, then press CANCEL.  To page 
through the list, press CH    or   .

When your VCR is the current device, REC (record) on 
the TV’s remote control functions the same as the record 

button on the VCR’s remote control or front panel.

To record directly from antenna or cable:

•  Method 1

1.  Press DEVICE on the TV’s remote to display the 

Device Selection menu.  Highlight the traditional 

VCR and press POWER to turn on the VCR.  If 

necessary, press GUIDE to select the input the 

VCR is on, such as Antenna input (or line input).

2.  Press ENTER to switch the TV to the VCR.
3.  Select the correct channel for recording on the 

VCR and then press REC to start recording.  You 

will need to manually stop the recording at the 
end of the program

•  Method 2

With the VCR as the current recording device, press 
the DEVICE MENU button to display the VCR’s menu, 

in which you can schedule a delayed recording 
directly from antenna or cable.

To record from ANT-1, ANT-2 or other devices, see 

NetCommand Controlled Recordings or refer to the TV 

Guide On Screen® User’s Guide.