Quantum govault 40gb Guia De Configuração Rápida

Installing the External GoVault Tabletop Dock

Use Windows 

 to verify successful GoVault installation and 

configuration (see 

Perform a number of file copy operations to and from the GoVault cartridge to verify 

the disk read/write functions.

If you are going to install both the GoVault system application software and the 

backup application software, then proceed to 

If you are not going to install the GoVault system application software, then skip to 

Figure 8  Successful 
Configuration Display

Installing the External GoVault Tabletop Dock

Install the external GoVault Tabletop dock and cartridge as follows:

Connect the drive-end (Mini-B) connector of the USB interface cable to the Mini-B 

USB port on the rear panel of the GoVault Tabletop dock (see 

Connect the DC power output plug of the power adapter/converter to the DC power 

jack on the rear panel of the dock.

Carefully position the dock in a secure location that provides adequate circulation for 

the rear panel air vents (see 

If you do not install the GoVault system application software, the 

Windows operating system might assign the low-speed Programmed I/O 

(PIO) mode for GoVault data transfer operations. Use the procedures in 

appendix B of the GoVault for Windows User’s Guide to determine if this is 

the case and, if necessary, configure the operating system to use the high-

speed Direct Memory Access (DMA) mode for GoVault data transfer 

operations.

GoVault