Roland v-synth xt Manual Do Proprietário
123
Settings Common to All Modes (System Mode)
Settings Common to All Modes (System Mode)
Functions of System Parameters
This section explains what the different System parameters do, and
also how these parameters are organized.
also how these parameters are organized.
Settings Common to the Entire System
(Common)
Master
fig.05-01_50
Master Tune
Adjusts the overall tuning of the V-Synth XT. The display shows the
frequency of the A4 note (center A).
frequency of the A4 note (center A).
Value:
415.3–466.2 Hz
Master Key Shift
Shifts the overall pitch of the V-Synth XT in semitone steps.
Value:
-24– +24
Master Level
Adjusts the volume of the entire V-Synth XT.
Value:
0–127
Patch Remain (Patch Remain Switch)
Specifies whether currently sounding notes will continue sounding
when another patch is selected (ON), or not (OFF).
when another patch is selected (ON), or not (OFF).
* This function is valid only when the effect is turned off.
Also, when this is “ON,” changes produced by incoming MIDI
messages such as Volume (CC 7) or Pan (CC 10), as well as tonal
quality and volume changes produced by the various controllers will
be inherited.
messages such as Volume (CC 7) or Pan (CC 10), as well as tonal
quality and volume changes produced by the various controllers will
be inherited.
Value:
OFF, ON
Effects settings change as soon as you switch to a new patch,
without being influenced by the Patch Remain setting. Because
of this, certain effects settings can cause notes that were until
then sounding to no longer be heard, even though Patch Remain
has been set to on.
without being influenced by the Patch Remain setting. Because
of this, certain effects settings can cause notes that were until
then sounding to no longer be heard, even though Patch Remain
has been set to on.
Powerup Mode
Specifies the condition that the V-Synth XT will be in when the
power is turned on.
power is turned on.
Value
LAST SET:
Reinstates the patch selected at the time the V-Synth XT
was last turned off.
DEFAULT:
The V-Synth XT will be ready to play Patch “001.”
IO
fig.05-01a_50
External Input Type
Value
STEREO L R:
Input in stereo.
MONO MIX:
Mix the L and R input signals and input in monaural.
MONO L:
Input the L signal in monaural.
MONO R:
Input the R signal in monaural.
The signal from the front panel mic jack is input to the right (R)
channel.
channel.
External Input Source
Selects the source of external input used when Oscillator Type (p. 86)
is set to “EXT IN.”
is set to “EXT IN.”
Value
Analog (MIC/INPUT):
The MIC jack or INPUT jacks will be the input
source.
USB Audio:
The USB audio from a computer connected to the V-
Synth XT will be the input source.
V-SYNTH_XT_e2 123 ページ ２００５年３月２３日 水曜日 午後４時３９分