Roland v-synth xt Manual Do Proprietário

 

If the this unit does not function in the way you expect, first check the following points. If this does not resolve the 
problem, consult your dealer or a nearby Roland Service Station.

 

Is the AC cord connected correctly to the V-Synth XT 
and to an AC outlet?

Check the AC cord connections.

 

Is the power of the connected devices turned on?

Make sure that the power of your amp or mixer system 
is turned on.

Is the volume turned down?

Check the volume of the V-Synth XT and of the con-
nected amp or mixer.

Is there sound in the headphones?

If there is sound in the headphones, it is possible that 
the connection cables are broken, or that the amp or 
mixer is malfunctioning. Check the connection cables 
and your other equipment once again.

Is the Patch level set too low?

Are the Effect settings correct?

Check the Effect settings ON or OFF, in the Effect Bal-
ance or Level (p. 97).

Are the settings for the output destination correct?

Have volume messages been received from an external 
MIDI device to lower the volume?

Check the volume.

Could the oscillator be off?

Turn on the [OSC1] or [OSC2].

Could the V-Synth XT be set to USB communication in 
Storage function?

Does the MIDI channel of the transmitting device (e.g., 
MIDI keyboard) match the MIDI channel of the V-
Synth XT?

Set the transmitting device (e.g., MIDI keyboard) and 
the V-Synth XT to the same MIDI channel.
Check the 

 

 

Could you be using a connection cable that contains a 
resistor?

 

926

 

Use a connection cable that does not contain a resistor.

Is the 

 

Check the 

 

 

Is the 

 

 

Check the 

 

 

 

Are the Pitch settings of the Oscillator section correct? Check the Coarse Tune/Fine Tune parameter settings 

Is the Master Tune setting correct?

Has a Pitch Bend message been received from an exter-
nal device, leaving the pitch “hanging?”

Try moving the pitch bend lever of the connected MIDI 
keyboard.

 

Is an effect which distorts the sound being applied?

Has the Patch level been turned up?

 

[MFX], [CHO], or [REV] effect switches may have been 
turned off.

Turn them on.

Are the various effect settings correct?

If the send level of each effect is set to 0, the effect will 
not be applied. Check the settings (p. 97).
Even with send levels to each effect set at 0, effects are 
not applied if the MFX Master Level, the Chorus Mas-
ter Level, or the Reverb Master Level is set to 0. Check 
each setting (p. 97).
If Output Assign is set to other than “MULTI,” the 
MFX sound will not be output (p. 97).

 

If the oscillator is set to external input (EXT IN), you 
will not hear sound unless you play the MIDI key-
board.

Try playing the MIDI keyboard.

 

 (p. 123) setting correct? Check the 

 

Is the 

 

 

 

 

V-SYNTH_XT_e2 193 ページ ２００５年３月２３日　水曜日　午後４時３９分