AASTRA 53i Guia Do Utilizador

Advanced Network Settings

4-36

41-001160-00, Rev 01  Release 2.0  

IP Phone Administrator Guide

.

Use the following procedures to configure VLAN on the IP phone.

1

Click on Advanced Settings->Network->Type of Service,DSCP

.

2

Choose a Protocol (SIP, RTP, and/or RTCP), and enter a value from 0 to 63.

Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled, you will need to map 
the applicable priority to the Protocol setting as shown in the table 

on

 

For more information, see the section 

.

3

Click 

 to save your settings.

Note: The session prompts you to restart the IP phone to apply the configuration settings.

4

Select Operation->Reset and click 

..

VLAN is disabled by default. When you enable VLAN, the IP 

phones use the default settings for each VLAN parameter. You can 
change the default settings if required using the following procedure.