AASTRA 53i Guia Do Utilizador
Administrator Level Options
3-18
41-001160-00, Rev 01 Release 2.0
IP Phone Administrator Guide
Administrator Options
•
Explicit MWI Subscription Period
The requested duration, in seconds, before the MWI subscription times out.
The phone re-subscribes to MWI before the subscription period ends.
The requested duration, in seconds, before the MWI subscription times out.
The phone re-subscribes to MWI before the subscription period ends.
•
Send MAC Address in REGISTER Message
Adds an "Aastra-Mac:" header to the SIP REGISTER messages sent from the
phone to the call server, where the value is the MAC address of the phone.
Adds an "Aastra-Mac:" header to the SIP REGISTER messages sent from the
phone to the call server, where the value is the MAC address of the phone.
•
Send Line Number in REGISTER Message
Adds an "Aastra-Line:" header to the SIP REGISTER messages sent from the
phone to the call server, where the value is the line number that is being
registered.
Adds an "Aastra-Line:" header to the SIP REGISTER messages sent from the
phone to the call server, where the value is the line number that is being
registered.
•
Session Timer
The time, in seconds, that the IP phone uses to send periodic re-INVITE
requests to keep a session alive. The proxy uses these re-INVITE requests to
maintain the status' of the connected sessions. See RFC4028 for details.
Default is 0.
The time, in seconds, that the IP phone uses to send periodic re-INVITE
requests to keep a session alive. The proxy uses these re-INVITE requests to
maintain the status' of the connected sessions. See RFC4028 for details.
Default is 0.
•
Timer 1 and Timer 2
The time, in milliseconds, that applies to an IP phone session. These timers
are SIP transaction layer timers defined in RFC 3261. Timer 1 is an estimate
of the round-trip time (RTT). Timer 2 represents the amount of time a
non-INVITE server transaction takes to respond to a request.
The time, in milliseconds, that applies to an IP phone session. These timers
are SIP transaction layer timers defined in RFC 3261. Timer 1 is an estimate
of the round-trip time (RTT). Timer 2 represents the amount of time a
non-INVITE server transaction takes to respond to a request.
•
Transaction timer
The amount of time, in
milliseconds that the phone allows the callserver (registrar/proxy) to respond
to SIP messages that it sends. If the phone does not receive a response in the
amount of time designated for this parameter, the phone assumes the message
has timed out. Valid values are 4000 to 64000. Default is 4000.
The amount of time, in
milliseconds that the phone allows the callserver (registrar/proxy) to respond
to SIP messages that it sends. If the phone does not receive a response in the
amount of time designated for this parameter, the phone assumes the message
has timed out. Valid values are 4000 to 64000. Default is 4000.
•
Transport Protocol
The protocol that the RTP port on the IP phone uses to send out RTP packets.
Valid values are 0 (both), 1 (UDP), or 2 (TCP). Default is 1 (UDP).
The protocol that the RTP port on the IP phone uses to send out RTP packets.
Valid values are 0 (both), 1 (UDP), or 2 (TCP). Default is 1 (UDP).
•
Registration Failed Retry Timer
Specifies the time, in seconds, that the phone waits between registration
attempts when a registration is rejected by the registrar.
Specifies the time, in seconds, that the phone waits between registration
attempts when a registration is rejected by the registrar.
•
Registration Timeout Retry Timer
Specifies the length of time, in seconds, that the phone waits until it
re-attempts to register after a REGISTER message times out.
Specifies the length of time, in seconds, that the phone waits until it
re-attempts to register after a REGISTER message times out.