Enterasys csx200 Guia Do Utilizador
Installation
26 CSX200 Family User’s Guide
Installing Interface Modules
Depending on your specific application, install Cableton Systems WAN Port Interface Modules
(WPIMs) and the CSX-COMP/ENCR modules into the CSX200 before proceeding with the
installation of your CSX200. Refer to the
(WPIMs) and the CSX-COMP/ENCR modules into the CSX200 before proceeding with the
installation of your CSX200. Refer to the
and
Removing the CSX200 Cover
This section describes how to remove the CSX200 chassis cover. The cover must be removed to
install a WAN Port Interface Module.
install a WAN Port Interface Module.
!
CAUTION
The WPIM, CSX200-COMP/ENCR, and the CSX200 are sensitive to static
discharges. Use a grounding strap and observe all static precautions during
installation. Failure to do so could result in damage to the WPIM, CSX200-COMP/
ENCR and the CSX200.
discharges. Use a grounding strap and observe all static precautions during
installation. Failure to do so could result in damage to the WPIM, CSX200-COMP/
ENCR and the CSX200.
NOTE
The CSX200 must have a WPIM installed before you can begin configuring the device.
!
CAUTION
DO NOT REMOVE THE COVER FROM THE CSX200 WHILE POWER IS APPLIED
TO THE UNIT.
TO THE UNIT.
DO NOT POWER UP THE DEVICE AGAIN UNTIL THE COVER AND SCREWS ARE
IN PLACE.
IN PLACE.
DECKEL VON DAS CSX200 NICHT ABZIEHEN UNTER SPANNUNG.
CSX200 NICHEINSCHALTEN SO LANG DER DECKEL UND SCHRAUBEN NICHT
EINGEBAUT SIND.
EINGEBAUT SIND.
NO DEBE DE REMOVER LA TAPA DURENTE QUE ESTE CONELTADO A LA
CORRIENTE.
CORRIENTE.
NO ENCHUFE A LA CORRIENTE HASTA QUE LA TAPA Y LOS TORNILLOS ESTEN
EN SU LUGAR.
EN SU LUGAR.