Enterasys ssr-glx19-02 Guia Do Utilizador
Chapter 11: Configuring the SSR for IPX Routes
172
CoreWatch User’s Manual
traffic, outbound traffic, or both inbound and outbound traffic.
Inbound traffic is packets coming into the interface while outbound traffic is
packets going out of that interface.
packets going out of that interface.
Select Input to filter inbound traffic. Select Output to filter outbound traffic.
Selecting both check boxes filters both inbound and outbound traffic.
Selecting both check boxes filters both inbound and outbound traffic.
You can apply up to two of each of the different IPX ACLs (IPX, IPX RIP, and IPX
SAP) to an IPX interface. When applying two ACLs of the same type, one ACL
must govern the inbound traffic and the other must govern the outbound traffic. If
you want to apply multiple ACLs to an IPX interface, finish using the wizard to
apply an ACL. Then apply the additional ACLs as discussed in
SAP) to an IPX interface. When applying two ACLs of the same type, one ACL
must govern the inbound traffic and the other must govern the outbound traffic. If
you want to apply multiple ACLs to an IPX interface, finish using the wizard to
apply an ACL. Then apply the additional ACLs as discussed in
.
c.
Click Finish.
Configuration Expert adds the new interface to those found in the IPX interfaces
bound to VLAN object.
bound to VLAN object.
Note:
When you apply an ACL to an interface, the SSR appends an implicit
deny rule to that ACL. The implicit deny rule denies all traffic. If you
intend to allow all traffic that does not match your specified ACL rules to
go through, you must explicitly define a rule to permit all traffic. To do so,
make sure the last rule of the ACL permits all traffic.
deny rule to that ACL. The implicit deny rule denies all traffic. If you
intend to allow all traffic that does not match your specified ACL rules to
go through, you must explicitly define a rule to permit all traffic. To do so,
make sure the last rule of the ACL permits all traffic.
Modifying IPX Interface Definitions
Modify IPX interface definitions to perform the following operations:
•
Change the interface’s name
•
Disable or enable the interface
•
Change the interface’s MAC encapsulation
•
Change the IPX address of the interface
•
Bind a different port or VLAN to the interface
•
Apply a different ACL to the interface
•
Change which traffic an interface’s ACL filters out
To modify an IPX interface definition:
1.
Start Configuration Expert if you have not already done so.
2.
Open the configuration file you want to modify and then double-click that file’s
Routing Configuration object.
Routing Configuration object.
3.
Double-click the IPX Routing Configuration object.