Memorex scrollpro Guia Do Utilizador

Página de 5
              switch the mouse to 'MS' mode when first installing the mouse 
       driver. After completing the installation, you can switch 
       to 'PC' mouse mode when you restart the computer. 
 
 
5. Trouble Shooting 
    Symptom 1 : No mouse movement. 
  Solution :   Make sure the software that you are using supports a mouse. 
   
- Check that mouse is plugged into serial port at the back of computer. 
        - Ensure that mouse driver is installed on the system. 
 
    Symptom 2 : The cursor remains in one spot or moves erratically. 
  Solution:    Check the mouse cable for any breaks or sharp twists.    Examine 
             the cable closely where it connects to the mouse. 
 
    Symptom 3 : The cursor movement stops at a corner and no longer responds 
                          to the mouse movement. 
    Solution:        Run the mouse driver to check which mode the mouse is operating 
                          in. 
 
    Symptom 4 : Mouse movement does not produce corresponding cursor movement 
             or there is a brief pause during movement. 
  Solution:    Clean the silicon rubber-coated ball and rollers. 
 
Symptom 5: After selecting mouse type the mouse became disabled when clicking 
                      "OK" . 
    Solution :    Use the keyboard to close the current window and wait for 
            any instruction to restart your computer.    After restarting the mouse 
            should work normally. 
 
    Symptom 6: Error Code 115 is displayed when installing the Mouse Driver 
Software 
Solution:      Shut down any virus protection software before installing the mouse 
                    software. 
 
    Symptom 7: Detection Problems with PS/2 Pointing Devices 
  Solution:   If your mouse is connected to the mouse port and is not detected 
                        by the system, attempt the following step(s):