Lenovo a58e 0841 Manual Suplementar
Replacing the system board
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and
wait three to five minutes to let the computer cool before opening the computer
cover.
wait three to five minutes to let the computer cool before opening the computer
cover.
Attention
Do not open your computer or attempt any repair before reading and understanding the
“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
“Important safety information” in the ThinkCentre Safety and Warranty Guide that came with
your computer. To obtain a copy of the ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
Note:
When replacing the system board a new retention module for the
microprocessor heat sink is required. Make sure you have a new retention
module before beginning this procedure.
microprocessor heat sink is required. Make sure you have a new retention
module before beginning this procedure.
This section provides instructions on how to remove and replace the system board.
The procedure varies depending upon the machine type.
The procedure varies depending upon the machine type.
1.
Remove the cover. See “Removing the computer cover” on page 83.
2.
Place the computer on its right side to help make the system board more
accessible.
accessible.
3.
Remove any adapter cards installed in the PCI connectors.
4.
Disconnect the signal and power cables from the hard disk drive and remove
the hard disk drive out of the chassis. See “Replacing the hard disk drive” on
page 99.
the hard disk drive out of the chassis. See “Replacing the hard disk drive” on
page 99.
5.
Disconnect the heat sink and fan assembly cable from the system board. And
lift the heat sink and fan assembly off the failing system board. See the system
board illustration for your machine type at “System board connectors” on
page 82.
lift the heat sink and fan assembly off the failing system board. See the system
board illustration for your machine type at “System board connectors” on
page 82.
6.
Carefully take note of the location of all cable connections on the system
board and disconnect all cables. See the system board illustration for your
machine type at “System board connectors” on page 82.
board and disconnect all cables. See the system board illustration for your
machine type at “System board connectors” on page 82.
7.
Remove the screws that secure the system board to the chassis.
8.
Remove the failing system board out of the chassis.
9.
The failing system board must be returned with a microprocessor socket cover
to protect the pins during shipping and handling. Install the microprocessor
socket cover removed from the new system board on the failing system board.
To install the microprocessor socket cover:
a.
to protect the pins during shipping and handling. Install the microprocessor
socket cover removed from the new system board on the failing system board.
To install the microprocessor socket cover:
a.
Make sure the microprocessor has been removed from the microprocessor
socket, and then close the microprocessor retainer and lock it into position
with the small handle.
socket, and then close the microprocessor retainer and lock it into position
with the small handle.
b.
Insert the tabs 1 of the socket cover into the hinged side of the socket,
and then press the other side of the socket cover downward until the tabs
2 snap into position.
and then press the other side of the socket cover downward until the tabs
2 snap into position.
88
Hardware Maintenance Manual