Lenovo edge 71 1578 Guia Do Utilizador
Figure 36. Installing the heat sink fan duct
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to “Completing the parts replacement” on page 56.
Replacing the microprocessor
Attention: Do not open your computer or attempt any repair before reading and understanding the “Important
safety information” on page v.
safety information” on page v.
This section provides instructions on how to replace the microprocessor.
CAUTION:
The heat sink and microprocessor might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
minutes to let the computer cool before removing the computer cover.
To replace the microprocessor, do the following:
1. Turn off the computer and disconnect all power cords from electrical outlets.
2. Remove the computer cover. See “Removing the computer cover” on page 30.
3. Remove the heat sink and fan assembly. See “Replacing the heat sink and fan assembly” on page 47.
Note: Place the heat sink and fan assembly on its side so that the thermal grease on the bottom of it
does not get in contact with anything.
does not get in contact with anything.
4. Locate the system board and disconnect all cables connected to the system board. See “Locating
50
ThinkCentre User Guide