Lenovo m58 6239 Guia Do Utilizador
6.
Install the drive into the bay.
7.
To reinstall the front bezel, align the plastic tabs on the right side of the front
bezel with the corresponding holes in the chassis, then pivot the front bezel
inward until it snaps into position on the left side.
bezel with the corresponding holes in the chassis, then pivot the front bezel
inward until it snaps into position on the left side.
8.
Continue at “Connecting a SATA drive.”
Connecting a SATA drive
A SATA optical drive or a SATA hard disk drive can be connected to any available
SATA connector on the system board.
1.
SATA connector on the system board.
1.
Locate the signal cable that comes with the new drive.
2.
Locate an available SATA connector on the system board. See “Locating parts
on the system board” on page 11.
on the system board” on page 11.
3.
Connect one end of the signal cable to the drive and the other end to the
available SATA connector on the system board.
available SATA connector on the system board.
Figure 14. Installing the drive
Chapter 2. Installing options and replacing hardware
23