Sceptre s6500 Guia Do Utilizador
Notebook User’s Guide
82
Cover Lid Switch
The Notebook’s LCD Cover Lid Switch is located to the right of the System
Status window. See Figure 1-4. If the Notebook is powered on and the lid is
closed, the LCD panel will power off and the display will be switched to the
CRT monitor connected to the VGA port. If a CRT monitor is not connected
to the Notebook, the system will enter suspend mode. Opening the cover will
resume the system to full power operation.
Status window. See Figure 1-4. If the Notebook is powered on and the lid is
closed, the LCD panel will power off and the display will be switched to the
CRT monitor connected to the VGA port. If a CRT monitor is not connected
to the Notebook, the system will enter suspend mode. Opening the cover will
resume the system to full power operation.
If the LCD Lid Switch is depressed for less than two
seconds, it will be ignored by the system.
seconds, it will be ignored by the system.
Reactivating From Power Saving Modes
After entering one of the power saving modes, the system will return to normal
operation in various ways depending on current system status. All of this is
transparent to the user. From the user’s point of view, the computer reactivates
almost as soon as you start to use it again.
operation in various ways depending on current system status. All of this is
transparent to the user. From the user’s point of view, the computer reactivates
almost as soon as you start to use it again.
Power Management Summary
The following table summarizes the power-saving features of the Notebook:
Power Mode
How to Enter Mode
How to Reactivate
Standby
Transits automatically after
specified timeout
specified timeout
Press any key
MODEM
ring, if the Setup program
field for this feature is set to Enabled
Touch Pad entry or a PS/2 mouse
activity if one is connected
activity if one is connected
Suspend to
RAM
RAM
Transits automatically after
specified time-out
specified time-out
Cover is closed
Press [Fn] + [R] hot key
Press the On/Off Power button
MODEM
ring, if the Setup program
field for this feature is set to Enabled
Resume Time, if the value for the
Resume On Time field in the Setup
program is set to On
Resume On Time field in the Setup
program is set to On
Save to
Disk
Disk
Transits automatically after
specified timeout
specified timeout
Critical battery condition
Press [Fn] + [F12]
Press the On/Off Power button