Lenovo m90z 0800 Guia Do Utilizador
6.
To install a new optical drive, slide the new optical drive into the optical drive
bay until it snaps into position.
bay until it snaps into position.
What to do next:
v
To work with another piece of hardware, go to the appropriate section.
v
To complete the installation or replacement, go to “Completing the parts
replacement” on page 55.
replacement” on page 55.
Replacing the heat sink
Attention
Do not open your computer or attempt any repair before reading and
understanding the “Important safety information” in the ThinkCentre Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
understanding the “Important safety information” in the ThinkCentre Safety
and Warranty Guide that came with your computer. To obtain a copy of the
ThinkCentre Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the heat sink.
CAUTION:
The heat sink might be very hot. Turn off the computer and wait three to five
minutes to let the computer cool before removing the computer cover.
minutes to let the computer cool before removing the computer cover.
To replace the heat sink, do the following:
1.
Remove all media from the drives and turn off all attached devices and the
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
computer. Then, disconnect all power cords from electrical outlets and
disconnect all cables that are connected to the computer.
2.
Place a soft, clean towel or cloth on the desk or surface. Hold the sides of
your computer and gently lay it down so that the screen is against the surface
and the cover is facing up.
your computer and gently lay it down so that the screen is against the surface
and the cover is facing up.
Figure 21. Installing the optical drive
30
User Guide